Hoppe Mortise Lock, 1" Deadbolt throw, 60/92 Single Point Lock (SPL), Rotation Limiter

This will NOT work for replacing the lock body on multipoint lock units. This is a single point lock only.
Hoppe Mortise Lock, Manual Gear, Single Point with 1 inch (25mm) Deadbolt throw
Used by Caradco, Jeldwen, Norco and others.
 
Stainless face plate 5/8 (16mm) inch wide x 10-7/8 inches long
Face plate screw holes are spaced 10-1/8 inch
Backset: 2-3/8 inch (60mm) - distance from edge of face plate to center of lock handle

All Current Model Single Point Locks from HOPPE w/ Rotation Limiter
(Lever is fixed and does not move after door is locked)
11517463 - 35mm backset, 14mm deadbolt throw, 16mm faceplate with radius ends
11517475 - 35mm backset, 25.4mm deadbolt throw, 16mm faceplate with radius ends
11517487 - 45mm backset, 14mm deadbolt throw, 16mm faceplate with radius ends
11517499 - 45mm backset, 25.4mm deadbolt throw, 16mm faceplate with radius ends
11517505 (this listing) - 60mm backset, 25.4mm deadbolt throw, 16mm faceplate with radius ends
11517517 - 70mm backset, 25.4mm deadbolt throw, 16mm faceplate with radius ends
11517529 - 35mm backset, 25.4mm deadbolt throw, 16mm faceplate with square ends

(Please contact office if needing one of the locks not currently linked to our site) Latch handing may be changed by pulling out or inserting small screwdriver into small hole in back of latch and pushing forward, twist latch and release. See linked article below.

HOPPE Screws for Installation:
8785695 - Screw 1-3/8" ( 35mm ) 8mm Head - Stainless Steel
8785687 - Screws, 3/4" (20mm ) 8mm Head - Stainless Steel


Helpful Articles
How To Drill Out A HOPPE Mortise Lock If The Dead Bolt Doesn't Retract
How to Change the Handing (Reverse the Slope of the Latch) on a HOPPE Lock