Replacement Kit for 71 - 85-5/8 inch OLD STYLE Tongue Version, 35mm backset
Replacement kit for discontinued old style tongue version multipoint locks with a 35 mm backset.
The replacement features 2 Tongue Latch locking devices.
One is located 29-1/4" above the center of the Handle Cylinder.
The other is located 26-7/16" below the center of the Handle Cylinder.
Please check your measurements carefully to insure you have the correct replacement.
Discontinued Lock Measurements:
Overall Length: 71 - 85-5/8 inches (lengths may vary)
Backset: 1-3/8 inch (35mm)
Faceplate Width: 5/8 inch (16 mm)
Handle Height: 36 inch ( 914mm)
Handle Spacing (PZ): 3-5/8 inch (92 mm)
Top Tongue Position: 29-1/2 inches above center of Handle Cylinder
Bottom Tongue Position: 26 inches below center of Handle Cylinder
Replacement Kit Measurements:
Overall Length: 71 - 85-5/8 inches
Backset: 1-3/8 inch (35mm)
FaceplateWidth: 5/8 inch (16 mm)
Handle Height: 36 inch ( 914mm)
Handle Spacing (PZ): 92 mm (3-5/8")
Top Tongue Position: 29-1/4" above center of Handle Cylinder
Bottom Tongue Position: 26-7/16" below center of Handle Cylinder
This is the easiest replacement currently available and will require the least amount of work.
As you can see above, the critical measurements of the two locks are almost identical.
Priced and sold as a kit.
Additional Resources:
How to change handing on HOPPE multipoint lock: Written Article | Video
Article: How to change direction of mishandling device on HOPPE lock
Attaching HOPPE Multipoint Lock Top Extension
Rehanding a Hoppe HLS9000 Multipoint Lock
The replacement features 2 Tongue Latch locking devices.
One is located 29-1/4" above the center of the Handle Cylinder.
The other is located 26-7/16" below the center of the Handle Cylinder.
Please check your measurements carefully to insure you have the correct replacement.
Discontinued Lock Measurements:
Overall Length: 71 - 85-5/8 inches (lengths may vary)
Backset: 1-3/8 inch (35mm)
Faceplate Width: 5/8 inch (16 mm)
Handle Height: 36 inch ( 914mm)
Handle Spacing (PZ): 3-5/8 inch (92 mm)
Top Tongue Position: 29-1/2 inches above center of Handle Cylinder
Bottom Tongue Position: 26 inches below center of Handle Cylinder
Replacement Kit Measurements:
Overall Length: 71 - 85-5/8 inches
Backset: 1-3/8 inch (35mm)
FaceplateWidth: 5/8 inch (16 mm)
Handle Height: 36 inch ( 914mm)
Handle Spacing (PZ): 92 mm (3-5/8")
Top Tongue Position: 29-1/4" above center of Handle Cylinder
Bottom Tongue Position: 26-7/16" below center of Handle Cylinder
This is the easiest replacement currently available and will require the least amount of work.
As you can see above, the critical measurements of the two locks are almost identical.
Priced and sold as a kit.
Additional Resources:
How to change handing on HOPPE multipoint lock: Written Article | Video
Article: How to change direction of mishandling device on HOPPE lock
Attaching HOPPE Multipoint Lock Top Extension
Rehanding a Hoppe HLS9000 Multipoint Lock