Hoppe HLS9000 Replacement Multipoint Lock Case Only

SKU: HoppeLC
Backset :
Bolt Throw :
QuantityPrice

Details

Hoppe HLS9000 Multipoint Lock Case (Gear Box Only) - Fixes Sagging or Droopy Handle or Broken Gear

Only Works with current style HLS9000 Multipoint Locks with Stainless Steel Faceplate, not the old style

This is a lock case only replacement part for a Hoppe HLS9000 multi-point lock with the mis-handing latch. We also have an extensive collection of complete Hoppe multipoint locks, extensions, and other parts available; see Related Items below or browse our menu for other offerings.

Available in many sizes. Determine the configuration of the lock you are replacing, then choose from four backset options and two deadbolt throw lengths.

Backset lengths:

  • 35mm (1-3/8 inches)
  • 45mm (1-3/4 inches)
  • 60mm (2-3/8 inches)
  • 70mm (2-3/4 inches)

Standard deadbolt throw is 1 inch, but a half-inch deadbolt throw is available.

Due to the way this is manufactured, you can use this to replace an HLS9000 Hoppe lock assembly containing a 16mm or 20mm faceplate width.

Measurements for backset and deadbolt throw are measured from the faceplate. When viewing measurement photos, consider that these lock case only parts do not have the 2mm faceplate attached.

To replace your lock case: Remove lock case from lower assembly, save upper and lower faceplate extensions.
See the VIDEOS TAB for more info

VIdeos

Step-By-Step Instructions:

  1. Remove existing lock case from upper and lower extensions. #3 Tri-Wing Bit
  2. Attach lower extension to new lock case.
  3. Attach upper extension to new lock case.
  4. Re-install multipoint lock assembly back in door with initial screws to hold in place.
  5. Test the lock is working properly (push in mis-handing latch to operate lock)
  6. If lock is working properly, finish installing installation screws. Do not over tighten; snug is good.
  7. Install handle set and key cylinder.
  8. Before closing door, test the lock again to be sure all locking points are extending and retracting properly.
  9. Close door and secure in locked position.
  10. If you have the spring latch facing the wrong direction, pull it out and spin it around. May require pliers.

Step-By-Step Instructions:

  1. Know that the backset is the distance from the edge of the door (or face of the lock box) to the center of the handle / spindle hole.
  2. Common Hoppe multipoint lock backsets are 1-3/8", 1-3/4", 2-3/8", and 2-3/4". Grab a tape measure.
  3. With a visible lock box: measure from the front of the lock box (faceplate) to the center of the spindle.
  4. If no hardware hole is visible: measure from the edge of the door to where the hardware hole would be. (Example: 2-3/8".)
  5. Patio door with extruded astragal: measure the same as the opposite door — from the faceplate to the center of the hardware hole.
  6. Keyed lock / cylinder style: measure from the edge of the door to the center of the hardware hole or lock cylinder. (Example: 2".)
  7. Storm door with a lip: measure from where the door edge would be if the lip were not there, to the center of the hardware hole. (Example: 7/8".)
  8. Door with no mechanism installed: measure from the edge of the door to the center of the mechanism hole. (Example: 2-3/4".)
  9. Write down your measurement and use it when ordering a replacement Hoppe multipoint lock.