PanoLock Multipoint lock for Standard deadbolt and locksets - Bronze

Endura PanoLock Multipoint lock that uses standard latch & deadbolt handle sets (knob, lever or grip)
(compatible with Schlage, Kwikset, Gatehouse, Baldwin, Brinks, Masterlock and Defiant - Does NOT work with all models) and may NOT be compatible with Electronic Deadbolts.

Series 1000 PanoLock:
Lock Backset: 2-3/8 inch
Faceplate Width: 1 inch wide
Faceplate Length, Active: 6/8 = 57-3/4" or 8/0 = 73-3/4"
Faceplate Ends: Radius
Handed: No, Reversible by removing screw and flipping latch
Faceplate colors: Bronze or Clear Anodized (dull silver)

Series 1375 PanoLock:
Lock Backset: 2-3/8 inch
Faceplate Width: 1-3/8 inch wide
Faceplate Length, Active: 6/8 = 57-3/4" or 8/0 = 73-3/4"
Faceplate Ends: Radius
Handed: No, Reversible by removing screw and flipping latch
Faceplate colors: Bronze or Clear Anodized (dull silver)

Door Mortise: Lock Center
Approximately 13-1/2 inches long and 3-3/4 inches deep. U-Channel Faceplate is 1 inch wide by 1/2 inch deep

Door Mortise: Upper and Lower Knife latches
Approximately 4 inches long and 2 inches deep. U-Channel Faceplate is 1 inch wide by 1/2 inch deep from top to bottom of radius corner faceplate

NOTE 1: The Panolock does not use the latches that come with a standard lockset. There are 9 adapters used for different brands of locks, Schlage, Kwikset, Etc.

NOTE 2: Adapters are inserted from the Composite side of lock, NOT the metal side

NOTE 3: When using a thumb latch entrance handle, there is an adjustment screws on the faceplate below the handle. Use a small flat head screwdriver to reduce or increase ( + / - ) force for thumb paddle sag.