Deadlatch Mortise Lock for store front aluminum narrow style doors
Steel construction Spring latch lock for commercial doors
Steel construction Dead Latch lock for commercial storefront doors
Latch goes out 3/4 inch
Deadlatch may allow exit only
Commonly used for traffic control after hours or when someone wants door to lock when closing.
Available in Aluminum and Bronze
Description: Mortise Lock 1-1/8 inch Backset, Steel, Aluminum Finish
Backset: 1-1/8 inch with 1/8 inch thick faceplate attached
Backset is measured from edge of lock face to center of cylinder
PLEASE NOTE THE FOLLOWING:
1). Deadlatch locks comes in 3 backsets: 31/32, 1-1/8, 1-1/2 inch, please check measurements carefully.
2). When Handing is changed, some Locks have a latch than can be pulled our and rotated 180 degrees to change handing. If latch will not pull out and rotate, you have a latch that has to be disassembled as shown in article.Changing the Handing on a Mortise Deadlatch