Use the arrows or swipe left to view all images for this product


20mm Double Door Active/Passive Multipoint Lock 69 - 82.5" Doors

Part Number: 4990617-KIT
Price: $395.00
Multipoint Lock Double Door Shootbolt Kit

Overall Length: 68" with radius ends
Faceplate Width: 25/32 (20mm)
Handle PZ: 3-5/8 (92mm)
Lock Cylinder: American Style
Backset: 1-3/4" (45mm)
Bottom Hook Position: 26-3/4" (replacement is Shootbolt)
Top Hook Position: 33-1/2" (replacement is Shootbolt)

Door Replacement Kit Components:
Active Door
20mm 45/92 Active Lower Shootbolt Gear
20mm Upper Shootbolt Extension
Stainless Steel Installation Screws

Passive Door
20mm 45/92 Passive Lower Shootbolt Gear
20mm Upper Shootbolt Extension
Stainless Steel Installation Screws

This kit does not include strike plate, latch ramp or handle set trim.

NOTE:
This replacement kit requires complete removal of existing ESSVE Multipoint locks on both doors.
Active Door requires complete (top to bottom) router for shootbolt replacmenet.
Passive door had a corner shootbolt return at top and bottom of door. This may be filled with lattice if desired, but not necessary.

ATRIUM DOORS - The original handle set trim for Atrium (Euro Cylinder Version) will not work; will require new trim.
MARVIN / PEASE DOORS - The original handle set trim for Marvin, Pease and others with American Version lock have installation screw hole spacing of 6-3/8. This trim will work with minor modifications to the lock body cylinder hole where the bottom screw goes though (a little tight, needs to be slightly enlarged with rasp).
Some PEASE doors had different Bore Hole spacing than others; the handle set trim was 2-3/8" wide, contact us if this is the case.

New Handle Set Trim Options:
If replacing we recommend the Expressions 2 x 12 Series Hardware

395009 - Modern, Square Top, Active Keyed
395010 - Passive
395007 - Traditional, Arch top, Active Keyed
395008 - Passive
Multipoint Lock Worksheet
ESSVE Lock Replacement Article (PDF) 
How To Trim / Crop Lock
Reverse Lock Handing
Change the direction of the spring latch by first extending the deadbolt (see lock operation below), pull out the spring latch and rotate accordingly.

Lock Operation: This lock has an Anti-Slam / Mishandling latch that needs to be pushed in to operate lock.
Lock: Lift the handle to extend deadbolt and other locking positions and turn thumb-turn to secure in locked position.
Unlock: Turn thumb-turn or key to unlocked position and push down on lever.