Andersen Storm Door Hardware, Oil Rubbed Bronze

Part Number: 306004
Price: $86.47

This product has been discontinued and is no longer available

Discontinued. Use 306005 as replacement


Special 1 inch Backset with special Off center cylinder
Handle can be used on Andersen 3000 & 4000 Series storm doors with a mortise lock and/or multipoint lock.

Euro-Style Profile Cylinder: Off-Center
Cylinder Type: offset tail piece
Overall length: 2-1/8 (55mm)
Inside Measurement: 1-1/4 (32mm) to screw hole
Outside Measurement: 7/8 inch (22mm) to screw hole
Keyway: Schlage 5 pin, SC1 Rekeyable, 2 keys

Mortise Lock Measurements:
Backset: 1 inch. Mortise lock body (standard is 7/8)
Backset is measured from edge of mortise lock to center of handle
Trim plate mounting screw holes: spaced 6-11/16 Inch
Door Thickness: 1-1/2 inch

Handle Style: Traditional
Handle Diameter Hole: 9/16 inch (standard 5/8 inch)
Handle Spindle: 5/16 Square, 3-1/4 Length
Color / Finish: Oil Rubbed Bronze
See Additional pictures - Click on image to enlarge

PLEASE NOTE
This Lock will work only on doors with these measurements,
Style might be different than current lock.
Old Style had a round hole for outside plate. (discontinued)
To reverse the handing of the Mortise Lock, simply remove the Faceplate and rotate the Spring Latch 180 degrees, then reconnect the faceplate.

Andersen / Emco Quick Change storm door mortise lock hardware with Lock bar uses 302047
Inside plate has thumb button to release Glass insert

Details on Andersen's Oil Rubbed Bronze and Distressed Bronze Finishes