Tongue Version Replacement Kit for Discontinued Roto (Roller or Tongue), and HOPPE (Tongue)
Also replaces HOPPE brand multipoint lock Tongue version.
For 79-3/16\" tall, active door with multi-point lock;
This Stainless Steel Replacement Kit includes: Locks, Strikes and Screws
One (1) Tongue Version lock body / gear for active doors
Two (2) Tongue curved lip Strike Plates - Stainless Steel
One (1) Latch and Deadbolt Strike Plate, curved lip, for standard 1-3/4 inch (45mm) thick door. - stainless steel
(23) Stainless Steel Screws.
NOTE: Stainless Steel is standard, if other finishes needed contact office
Fits doors from 71" to 85-1/2" (1805-2175mm)
Faceplate Width: 5/8" (16mm)
Backset: 1-3/4" (45mm)
Deadbolt Throw: 1 inch (25.4mm)
Handle Height: 36" (914mm)
Tongue Positions: (Measured from center of Handle Cylinder to bottom of Tongue)
Bottom Tongue: 26.42" (671mm)
Top Tongue: 29.25" (743mm)
Note: Strike plates may require relocation and will have to be replaced when converting from Roller to Tongue version. The original brass strike is longer than the replacement and will require patching door jamb or use existing strike.
The Tongue Strikes (top and bottom), when installed, will cover the old roller strike area.
Stainless Steel strike plates available in other finishes on request.
Sold as Kit, priced as kit.
Replacement Guide: How to Replace a Roto Lock in a Weather Shield Door
Additional Resources:
How to change handing on HOPPE multipoint lock: Written Article | Video
Article: How to change direction of mishandling device on HOPPE lock
Guide to Replacing Locks in Weather Shield Doors
Attaching HOPPE Multipoint Lock Top Extension
Rehanding a Hoppe HLS9000 Multipoint Lock