THE MANUFACTURE HAS MADE A REVISED DESIGN ON THE HANDLE BUSHING.
THIS HANDLESET MAY NOT WORK ON OLDER IPD LOCKS
IT IS DESIGNED TO WORK WITH THE NEW LOCK CASE.
THE BUSHING STOPS USE TO BE AT 9 & 3, THE NEW ONES ARE 10 & 2.
THIS WAS REDESIGNED TO REDUCE THE STRESS ON THE SPRINGS AND INCREASE LIFE SPAN OF PRODUCT.
1. Replace IPD lock
2. New handle set trim and New lock case
3. Cut stops on metal bushing back to 9 & 3
Old Citadel IPD French Hinged Door, (used with Multi-Point Lock) Used from 1980’s till 2002.
The IPD Swinger Hardware used a keyed American Cylinder with 1-1/4 inch long Flat Tail Piece, 2-1/4 Machine Screws for 1-3/4 thick door.
Inside and Outside handle set Polished Brass finish.
NOTE: This is the keyed trim only, NO mortise lock, NO Strike Plates.
This is for the multipoint lock. If your door does not have a bolt at both the bottom and the top as well as the standard middle location, then you are probably looking for #06200031.
Please check pictures for reference.
The mortise lock body that goes with this handle set are #37400034 and #37400035.