This is a Tongue Version Replacement Kit for the Discontinued Fuhr Roundbolt Multipoint Lock with a Backset of 55mm and a Faceplate Width of 20mm.
This Replacement Kit was developed for the above mentioned lock and may not work as a replacement for any other lock.

Please check your measurements carefully to insure you have the correct replacement.

Discontinued Fuhr Roundbolt Measurements:
Overall Length: 78 inches
Backset: 55mm (2-1/4")
Faceplate Width: 20mm (3/4")
Handle Height: 35"
Handle Spacing (PZ): 92mm (3-5/8")
Top Roundbolt Position: 28-3/4" above center of Handle Cylinder
Bottom Roundbolt Position: 25" below center of Handle Cylinder

Replacement Kit Measurements:
Overall Length: 71 - 78-3/4 inches
Backset: 60mm (2-3/8")
Faceplate: 20mm (3/4")
Handle Height: 36"
Handle Spacing (PZ): 92mm (3-5/8")
Top Roundbolt Position: 29-1/4" above center of Handle Cylinder
Bottom Roundbolt Position: 24-7/16" below center of Handle Cylinder

NOTE:
Due to the change in Backsets, the replacement will require you to slightly relocate the Handle Cylinder Hole on your door. (See Article) PENDING
The new Locking Device Strikes will need to be repositioned on the door jamb and may require you to chisel out a small portion of the jamb to function correctly.

For more information on Lock Comparisons and Installation, please see the appropriate Article. (PENDING)

Article: How to change handing (reverse direction of spring latch) on HOPPE multipoint lock
Article: How to change direction of mishandling device on HOPPE lock