Installing Stanley 7/16" Offset Dial Adjustable Hangers
Installing Stanley 7/16" Offset Dial Adjustable Hangers
The following instructions will explain how to install Stanley's 7/16" Offset Dial Adjustable Hangers for sliding closet door rollers.
- For sliding doors
- For 3/4" and 1-3/8" thick doors in conjunction with CD40-3192 dial adjustable hangers
- Features fine tune dial to provide up to 5/16" alignment of door to jamb.
- Acetal wheels for silent, smooth door operation.
- For doors up to 60 lbs.
- Hanger: Steel/Zinc plated; Wheel: Plastic/White
- For 1-3/8" doors: Use Part # 25410 (Stanley: CD40-3192) with 1/8" offset on front door, and Part # 25411 (Stanley: CD40-3188) with 7/16" offset on rear door. For 3/4" doors: Use Part # 25411 (Stanley: CD40-3188) on front door and Part # 25410 (Stanley: CD40-3192) hangers on rear door.
- Locate hangers on back of door 2-1/2" from each door edge. Use hangers as template and drill 3/32" pilot holes.
- Fasten screws.
- Hang rear door by tilting door approximately 15" to engage wheels in track.
- Repeat for front door.
- To align doors with jamb, lift door at side near jamb to remove door weight from hanger. Turn dial clockwise to lower door to counterclockwise to raise door.