Series 57/58 Roller Assembly Sliding Door Hardware is meant for 1-1/8 inch or thicker single sliding or bi-parting doors weighing up to 250 pounds each.**NOTE:The Acme series 57/58 sliding door roller assembly has been discontinued, but part #25061 is an available replacement for purchase at All About Doors & Windows.**
Trim your track so it is 1-1/2 inches shorter than the entire width of the opening of the door to allow for room to insert the four-wheel hangers.
Screw track to header. On a pocket door, make sure when you install your track that you leave the 1-1/2” clearance in the doorway, not in the pocket.
Insert four-wheel hangers into track with key slot facing the interior of the room.
Bore 2 holes, each 1/2 inch diameter by 1/4 inch deep in the top horizontal edge of the door. Make these holes 3 inches from either end of door.
Attach the top plates to the door, centering them directly over the newly-made holes and using holes to secure the plates in place.
Thread the pendant bolt into the top plate adjusting nut. Attach the door to the hanger by inserting the pendant bolt into the key slot in the hanger; rotate the pendant bolt 90 degrees to lock it into position. Turn the top plate nut with a wrench to adjust the door vertically for plumb and height.
Click below to download your own printable guide from All About Doors & Windows to help you install your roller assembly sliding door hardware.How to Install Acme Series 57/58 Sliding Door Roller Assembly Hardware