This Handleset Trim is used on the Peachtree IPD doors and Pella Entry doors with Trilennium Locks
The manufacturer has made a revised design on the handle bushing. This handleset may not work on older Peachtree IPD Locks.
It is designed to work with the new lock case. The bushing stops used to be at the 9 & 3 positions, but the new ones are at 10 & 2 positions. This was redesigned to reduce the stres on the springs and increase the life span of the product.
1. Replace IPD lock
2. New handle set trim and New lock case
3. Cut stops on metal bushing back to 9 & 3
Old Citadel IPD French Hinged Door, (used with Multi-Point Lock) Used from 1980s till 2002.
The IPD Swinger Hardware used a keyed American Cylinder with 1-1/4 inch long Flat Tail Piece, 2-1/4 Machine Screws for 1-3/4 thick door.
Inside and Outside handle set Polished Brass finish.
NOTE: This is the keyed trim only, NO mortise lock, NO Strike Plates.
This is for the multipoint lock. If your door does not have a bolt at both the bottom and the top as well as the standard middle location, then you are probably looking for #06200031.
Please check pictures for reference.
IMPORTANT NOTICE About new style Peachtree IPD levers.
The New design does not always retract the latch and may require modification of the bushing : See 40050
bushing for more info.