How to Install and Remove Eclipse™ Cylinder in Winkhaus One Motion™ Locks
How to Install and Remove Eclipse™ Cylinder in Winkhaus One Motion™ Locks
This guide is applicable for the following Eclipse™ cylinders:
413020360 (30/20 45mm full cylinder)
413530360 (35/30 57mm full cylinder)
410020460 (thumbturn-only half-cylinder)
Guide to installation is first; scroll down to see removal guide.
Eclipse™ Cylinder Installation
- Bring One Motion™ Lock into the disengaged position by pushing down the interior lever (all locking points will retract).
- Hold cylinder in mounting position (slim part of housing face up).
- Insert key into key-slot. Note: For half-knob cylinder, skip step 3.
- Align cylinder cam with cylinder housing:
- Insert needle tool through slot and into the small hole on spindle-side of cylinder. Push up with the needle tool to release the cylinder cam until it rotates freely.
- Rotate cam until it aligns with the cylinder housing
Insert cylinder body into the door from the outside (square shaft facing the interior). For half-knob cylinder: insert cylinder body into the door from the the inside (square shaft facing the interior).
IMPORTANT: Always turn shaft or key towards the outer edge of the door until cylinder cam engages. Turning in the opposite direction will engage cylinder cam in a non-functioning position. If it occurs, repeat the process being certain to rotate the knob or key toward the outer edge of the door.
- Secure cylinder in door with cylinder screw.
Eclipse™ Cylinder Removal
- Remove cylinder screw.
- Follow steps 3 and 4 of "Eclipse™ Cylinder Installation" guide.
- Pull cylinder body out of the door from the outside.