How to Install Float-Away Bifold Doors
How to Install Float-Away Bifold Doors
Install Track:
- Position upper track 5/8" (16mm) from edge.
- Center in opening
- Fasten with screws.
- Fasten bottom track directly below upper.
Hang Door:
- Insert threaded pivot pin (part #26558) in lower pivot block hole.
- Pull upper pivot pin down and engage in pivot block hole.
- Pull remaining pins down at top and up on bottom and engage in track.
Adjust Height:
- Loosen locknut.
- Turn threaded pivot pin until top of door is 1/8" (3mm) below track. Tighten locknut.
How to Install Handle on Mirror Door:
- Insert handle in slot on edge of door.
- Rotate handle 90 degrees.
- Push handle through slot.
- Secure handle to door flange.
How to Limit Door Travel (If Desired):
- Remove door.
- Unsnap upper guide pin from present location and snap into adjacent hole. Repeat for lower guide pin.
How to Adjust Doors Horizontally (If Necessary):
- If doors are not in line, loosen screws in top and bottom tracks.
- Shift tracks in opposite directions to correct. Tighten screws.
- **Note: If bottom track is fastened to cement, loosen pivot block screws and slide pivot blocks to correct.
Knob Installation for Non-Mirror Door:
How to Install Felt Pads:
- Remove felt pads from plastic bag. Peel pad from backing.
- Place pads on edge of door opposite each hinge.
Special Instructions to Change Opening Direction of Door:
- Remove door.
- Unsnap pins and move to similar location on opposite panel.
- Snap into holes.
Special instructions for Doors Without Knob Holes:
- Drill 3/16" hole in guide panel for knob.